6. WinEEM4 Service Tool User Guide

• 6.1. Home category
  • 6.1.1. Connecting to ECU
  • 6.1.2. System Information
  • 6.1.3. Software Update
    • 6.1.3.1. Requirements
    • 6.1.3.2. Software update procedure
• 6.2. System Status Category
  • 6.2.1. Engine status
  • 6.2.2. Aftertreatment Process
  • 6.2.3. Air system
• 6.3. Service Operations
  • 6.3.1. Service Information
  • 6.3.2. Service Parameters
  • 6.3.3. Injector calibration
  • 6.3.4. Catalyst cleanup
  • 6.3.5. DPF regeneration
  • 6.3.6. Catalyst exchange
• 6.4. ECU activation
  • 6.4.1. Requirements
  • 6.4.2. ECU activation procedure
  • 6.4.3. ECU activation removal procedure
  • 6.4.4. Specification Mismatch Override
• 6.5. Diagnostic category
  • 6.5.1. Save all logs
  • 6.5.2. Active Errors
  • 6.5.3. Emission Log
  • 6.5.4. Error Log
  • 6.5.5. Injector calibration log
  • 6.5.6. Software fingerprint log
  • 6.5.7. Software Log
  • 6.5.8. ECU temperature profile
  • 6.5.9. Drive cycle duration profile
  • 6.5.10. Engine Load Profile
  • 6.5.11. Shutdown Log
  • 6.5.12. Engine speed profile
  • 6.5.13. Event log
  • 6.5.14. Oil temperature profile
  • 6.5.15. Catalyst exchange log
  • 6.5.16. DEF concentration profile
  • 6.5.17. DEF tank refill log
  • 6.5.18. DPF delta pressure profile
  • 6.5.19. DPF event log
  • 6.5.20. DPF soot load profile
  • 6.5.21. DPF upstream temperature event histogram
  • 6.5.22. Exhaust back pressure profile
  • 6.5.23. SCR adaptation factor profile
  • 6.5.24. SCR event log
  • 6.5.25. SCR temperature profile
  • 6.5.26. SCR upstream temperature event histogram
• 6.6. Engine test category
  • 6.6.1. Actuator tests
  • 6.6.2. Cylinder cut-out test
  • 6.6.3. Engine compression test
  • 6.6.4. Engine rail high-pressure test
  • 6.6.5. Engine run-up test
  • 6.6.6. PCV hysteresis test
  • 6.6.7. Pressure delivery rate test
  • 6.6.8. Visco fan speed test
  • 6.6.9. Wiggle wire test
  • 6.6.10. Airsystem actuator tests
  • 6.6.11. DEF dosing rate test
  • 6.6.12. DEF tank heater test
  • 6.6.13. SCR system emptying test
  • 6.6.14. DEF pressure build-up test
• 6.7. Oscilloscope
  • 6.7.1. Using oscilloscope
  • 6.7.2. Recording
• 6.8. CAN Message Tracer
• 6.9. EEMService.com instructions
  • 6.9.1. Introduction
  • 6.9.2. Registering to EEMService.com
  • 6.9.3. ECU replacement procedure
  • 6.9.4. Injector calibration codes